翻譯求助: 裝載機操作注意事項!!

裝卸機器時的注意事項 機器的裝卸始終存在潛在的危險，應該極為小心。機器裝卸時，發(fā)動機要低速運轉，機器要低速行走。 機器裝卸要在堅固的平地上進行。與路邊保持安全距離。 機器裝卸要始終將運輸車的車輪固定好。 要使用專用裝卸平臺，或具有足夠強度的專用支架。要保證支架有足夠的寬度和長度，以提供一安全裝卸的斜坡，斜坡與地面之間的夾角不能超過15º。斜坡之間的距離要與機器的輪距相適應。 確保專用支架牢固定位，兩邊高度一致。 確保專用支架斜坡表面清潔，無潤滑劑、油漬、冰和松散的材料。將機器輪胎上的污物清除掉。 絕不可在斜坡上轉向。如有必要，機器應駛離斜坡，調整好方向之后再次開上去。 裝車運輸時，應在裝車后，將機器輪胎楔住，把機器用鋼絲繩扎緊。: 問提問者：網友 | 2017-06-10

最佳回答

Handling machinery at the Attention machines handling the potential danger always exists, it should be very careful. Loading and unloading machines, engines to low-speed operation, low-speed machines to run. machines working in the firm on the ground. And maintain a safe distance from the roadside. handling machines should always be properly fixed the wheel transporter. To use the platform for loading and unloading, or have sufficient strength for the stent. To ensure there is sufficient support the width and length, to provide a safe working slope, slope and the angle between the ground can not exceed 15 º. The distance between the slopes with a machine Lunju suit. ensure solid support for positioning, a high degree of consensus on both sides. ensure that the special stent surface cleaning, no lubricants, Youzi, ice and loose material. Machinery tires on the dirt removed. can not shift on the slopes. If necessary, pull off the slopes machines, adjusting the right direction again after a boost. loading of transport, should be loading, the machine will tire wedge to live, the machines used wire rope Zhajin.: 回答者：網友

產品精選

我來回答